Dipswitch9000
- Apr 19, 2022
- 1
- Joined
- Apr 19, 2022
- Messages
- 1
Greetings EP community,
I work at a Camp with a Miniature Golf course which we are renovating. Part of that renovation is the addition of a classic windmill complete with moving blades attached to a windshield wiper motor. My goal is to power it with the 110 I have available but also have it connected through a motion sensor at the beginning of the hole. That way a kid can walk up, swing their club in front of the sensor and set the blades to spinning.
If it is possible and I wanted the blades to run for 30 seconds before turning off, would that require something like an Arduino?
Thank you for any advice!
Dip
I work at a Camp with a Miniature Golf course which we are renovating. Part of that renovation is the addition of a classic windmill complete with moving blades attached to a windshield wiper motor. My goal is to power it with the 110 I have available but also have it connected through a motion sensor at the beginning of the hole. That way a kid can walk up, swing their club in front of the sensor and set the blades to spinning.
If it is possible and I wanted the blades to run for 30 seconds before turning off, would that require something like an Arduino?
Thank you for any advice!
Dip