Connect with us

Microwave Doppler detector

Discussion in 'Electronic Design' started by [email protected], Oct 13, 2007.

Scroll to continue with content
  1. Guest

    Dear all,

    I have bought a microwave Doppler detector to evaluate the detection
    distance. However, I find that its detection range is not as good as
    its claim, which describes that it can detect thieves outside the
    house through the door, and can be used to compute car velocity. I
    found that the free air space range is only about 1m using the CRO to
    see.

    The specification can be downloaded at here:

    http://www.apollounion.com/eweb/sen...er=120112&news_type=Microwave Sensors Modules

    Do I need to add external circuit to amplify and/or filter the output
    IF signal?

    Thanks!
     
  2. Phil Allison

    Phil Allison Guest

    <>


    ** Google Groper Alert !!



    ** As the " typical " output signal is only 200uV - you WILL need some
    amplification and processing.

    An op-amp ( like the NE5534) wired as a LPF with 100 to 100 times gain of
    should be a boon.




    ....... Phil
     
  3. Phil Allison

    Phil Allison Guest

    "Phil Allison"


    ....... Phil
     
  4. cell

    cell Guest

    I still cannot achieve the distance 20m as describe in the
    specification. In the datasheet it mentions to use pulse style supply
    voltage. Is it the key?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-