Connect with us

MC68HC908GZ8 Reading/programming

Discussion in 'Microcontrollers, Programming and IoT' started by shady, Apr 29, 2017.

Scroll to continue with content
  1. shady


    Aug 3, 2013
    I have this keypad controller board and i've come to a conclusion that the MC68HC908GZ8 is most likely faulty. I want to try and read the contents of the flash, however, this MCU is not listed on my Xprog-m 5.70. I know dataman programmer supports it but it's a bit pricey.
  2. Paul o Callaghan

    Paul o Callaghan

    May 27, 2017
    Orange5 programmer will read this and it's not very expensive
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day