Maker Pro
Maker Pro

[MAC+PHY] 10Mbit in a small package using an SPI interface?

M

Markus Meng

Jan 1, 1970
0
Hi all,

I was looking for a 10MBit ethernet mac+phy chip that allows to
communicate over an SPI port. Is someone aware of such a device?

I did found an USB chip, that does this, however that's not SPI

Best Regards
Markus
 
A

Antti Lukats

Jan 1, 1970
0
Markus Meng said:
Hi all,

I was looking for a 10MBit ethernet mac+phy chip that allows to
communicate over an SPI port. Is someone aware of such a device?

there is no SPI but W3100A from wiznet has I2C
well it requires additional phy chip :( - new version should have it
integrated but doesnt seem to be available
http://www.wiznet.co.kr/e_iinchip/index_e.htm


Antti
 
Top