Connect with us

Low Induction Modules?

Discussion in 'General Electronics Discussion' started by Thunderai, Mar 27, 2017.

Scroll to continue with content
  1. Thunderai

    Thunderai

    1
    0
    Mar 27, 2017
    In order to test my circuit I'm required to use loads of 1 Ohm and 100 Ohms (11V output). I was going to use resistors in parallel but the spec I'm working to says "low induction modules shall be used as resistors". Sorry to brain fart here but does that mean I have to use something different? Any help would be greatly appreciated.
     
  2. davenn

    davenn Moderator

    13,833
    1,950
    Sep 5, 2009

    hi
    welcome to EP :)

    tell us more about this test maybe even photo and upload the info about this test
     
  3. duke37

    duke37

    5,364
    771
    Jan 9, 2011
    The leads to a resistor will be inductive and wire wound resistors will be inductive.
    What power and frequency is involved.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-