Connect with us

Logical Devices prompro-8x "CNF" socket pinouts?

Discussion in 'Microcontrollers, Programming and IoT' started by Kapaneus, Nov 4, 2016.

Scroll to continue with content
  1. Kapaneus


    Nov 4, 2016
    Just acquired one of these, not realizing that it needed the little jumper-dongles in order to actually program an EPROM. (The host PC software was easy to come by and other functions seem to work.) If anyone knows what the configuration for a 27C512 jumper should look like, I'd appreciate it if you could post it. It came with one (jumpers on pins 1-16, 6-7 and 11-12) but the label is missing and I don't know what it's for.

    This subject has been brought up here before (in 2004) and nobody had anything on it. Perhaps in the meantime someone has come across a schematic or a set of dongles.

    At any rate, thanks for your trouble.
  2. dorke


    Jun 20, 2015
    Welcome to EP.
    Try contacting the company for help.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
Electronics Point Logo
Continue to site
Quote of the day