Connect with us

linear actuator 12/24V 6-7" extension 30-50lbs,fast 10mm/s

Wanted: Discussion in 'For Sale / Wanted' started by JOSH MC DONALD, Dec 7, 2017.

Thread Status:
Not open for further replies.
Scroll to continue with content
  1. JOSH MC DONALD

    JOSH MC DONALD

    1
    0
    Dec 7, 2017
    I need a linear actuator and controller kit where the actuator speed can be controlled, the length extended controlled (optional)
    and has a function where when it reaches the top and bottom limits it reverses. So more of an adjustable pump action where I can adjust speed and length of stroke which automatically reverses until shut off.

    If anyone knows a kit that is out there, the controller kit and the actuator I would be very grateful. I have the application just don't know enough to make my own controller. Please offer recommendations for the controller and actuator.

    Thank you so much.
     
  2. Minder

    Minder

    2,955
    624
    Apr 24, 2015
    I suspect you are going to need some degree of customization, a off the shelf solution may be hard to come by.!
    M..
     
  3. Fish4Fun

    Fish4Fun So long, and Thanks for all the Fish!

    462
    105
    Aug 27, 2013
    Hey Josh!

    You may need to offer a few, more salient, details :) Linear Actuators are readily available in a wide range of sizes, speeds, powers, resolutions, and OF COURSE prices, LoL. One that will push a pallet of bricks 25ft in 10 seconds with an accuracy of +/- 0.0005 inches is going to cost a lot more than one that needs to move a microscope slide 0.25 inches in 30 seconds with an accuracy of +/- 0.010 inches. I am certain you have an application in mind....you should either disclose what that application is, OR you need to define all of the relevant characteristics ... length of travel, maximum speed of travel, minimum acceleration, typical load: mass, volume, area, minimum acceptable accuracy, any rigidity requirements, etc, etc.

    Even with all of the above details, finding a solution that will "work" can be VERY different than finding a solution that is economically viable for a particular purpose. A Trash Compactor and a Garage Door Opener are two examples of "linear actuators" readily recognizable to most consumers and can be relatively cheap; however, neither has much use for anything except what it was designed for, nor are you likely to save any money attempting to build one yourself .... So, without knowing what you have in mind, there isn't much help anyone can offer.

    Fish
     
  4. Rb pana chair

    Rb pana chair

    2
    0
    Jan 3, 2018
    I have two linear screws from a panasonic massage chair for foot raise and back recline. Would those work?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Thread Status:
Not open for further replies.
Electronics Point Logo
Continue to site
Quote of the day

-