Connect with us

LEDs and resistors

Discussion in 'LEDs and Optoelectronics' started by tarrigo, Oct 19, 2010.

Scroll to continue with content
  1. tarrigo

    tarrigo

    1
    0
    Oct 19, 2010
    I have a 3.7 volt power source and a LED light that only supports up to 2.7 volts. So, I assume I need a resistor between the positive power source and the positive end of the LED.

    Would I be correct?
     
  2. LTX71CM

    LTX71CM

    182
    0
    May 23, 2010
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-