Connect with us

LDO AC analysis

Discussion in 'Electronic Basics' started by jutek, Jan 29, 2006.

Scroll to continue with content
  1. jutek

    jutek Guest

    hello

    could you tell me how to do AC open loop LDO simulation properly?

    how the inputs should be polarized when i open the loop to pass device
    give me the current i want to.

    when i do transient and op analyses, everything is ok. vref is connected
    to - and output voltage through feedback divider to +.

    i want the AC simulation to be adequate TRANSIENT simulation, to be sure
    how gain, UGF and pole/zero position influence transient response

    thanks in advance

    regards
     
  2. Chris

    Chris Guest

    http://www.nbp.pl/en/banknoty/banknoty/pln20.htm
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-