Connect with us

LCD Module???

Discussion in 'Electronic Basics' started by brazingo, Jan 22, 2006.

Scroll to continue with content
  1. brazingo

    brazingo Guest

    Hi there,
    I just salvaged a LCD Module (from TELXON PTS-710 Portable
    Data Terminal). Its working fine, but I am unable to find datasheets
    for the module. Its a 4-line x 16-character LCD; 5 x 7 dot matrix and
    has 16 pins and bakclight.
    How do I get the pin assignment for the module ? Is there a
    standard that the industry follows for pinouts in LCD modules ?
    I also found some interesting scriptures on the lcd module -
    1)EM9852
    2)610/710 DISPLAY
    3)ks0066u (LCD controller IC);
    4)ks0065bq (3 such ICs. Don't know what it does)
    5)fab rev107
    What numbers should i look for to get the dataskeets
     
  2. Dan Hollands

    Dan Hollands Guest

    The most useful info is usually the data sheet for the LCD controller.
     
  3. Rich Webb

    Rich Webb Guest

    The pin assignments that Optrex uses are fairly typical but NOT always
    what any given display may use. See page 11 of the manual at
    http://www.optrex.com/pdf/Dmcman_full.pdf Pins 15 and 16, when present,
    are often for the backlight.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-