Maker Pro
Maker Pro

LCD driver on digital clocks

R

Rick

Jan 1, 1970
0
Hello all,
I have two reasonably new digital LCD clocks that have a display that is
green background and black characters. On my wife's clock, it was so bright
at nite to keep her awake. I toned it down a bit by dimming the LED's that
lit it from behind. Now it is somewhat hard to read.
I think it would be better if I could reverse the display so that only the
characters are lit. I am not that familiar with LCD drivers, but is there
usually a pin on some (or all) of them that will reverse the display, or is
there some other trick I can use?
Sorry I dont have more info on the chips at this point, but if it isn't
possible, no sense cracking it open again. Thanks for any insight.
 
Top