Connect with us

large proto/experimenters board

Discussion in 'Electronic Components' started by Doug Parker, Jun 17, 2004.

Scroll to continue with content
  1. Doug Parker

    Doug Parker Guest

    I'm going to use a large, non-copper clad prototyping board for a
    project but I need a large (~ 200 mm to 250 mm minimum) square board
    that has predrilled holes ~6 mm apart. Hole sizes about 1.5 mm.

    Any sources?

    TIA

    Doug
    Orlando, FL
     
  2. Tim Shoppa

    Tim Shoppa Guest

    Vectorboard pattern G? The holes are 0.2" (about 5mm) apart (but not
    rectangular) and are 0.0625" diameter (1.5mm).

    Tim.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-