Connect with us

LabVIEW, sensors, drivers

Reply to Thread

Discussion in 'Datasheets, Manuals and Component Identification' started by ssousy, Jun 17, 2011.

Scroll to continue with content
  1. Jun 17, 2011 #1
    ssousy

    ssousy

    3
    0
    Jun 17, 2011
    I have this CMOS Sensor Inc. Contact Image Sensor (M206-A6C2) and I am trying to find out if it is compatible with National Instruments' LabVIEW software and hardware. Do I need a driver to use this? Does anyone have any advice on how to get started with reading data from this sensor? Any help is appreciated :)
     
  2. Jun 23, 2011 #2
    TBennettcc

    TBennettcc

    292
    2
    Dec 4, 2010
    Might try looking here.

    You might be able to set up a serial device inside of LabVIEW...

    Do you have an analog-to-digital converter (ADC)?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. H-300A Hall Effect Sensors

  2. Wind Speed measurement using ultrasonic sensors

  3. Cheap Motion sensors , chinese I think

  4. Needhams EMP-100 USB Programmer (need software and drivers disk)

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-