Maker Pro
Maker Pro

KA2206B pinout in datasheet from bottom-view?

Harald Kapp

Moderator
Moderator
Nov 17, 2011
13,700
Joined
Nov 17, 2011
Messages
13,700
I'd say you are right. The notch of the case is usually where pin 1 is, but as the notch is to the right pin 1 would be to the top right if this were a top view. Since Pin 1 is to the bottom right, this should be a bottom view.

Go to page 5 of the datasheet, there you will find the "usual" view of the IC.
 
Top