Connect with us

JDM PIC programmer

Discussion in 'Electronic Repair' started by [email protected], May 13, 2007.

  1. Guest

    Hello,
    A while ago I came across a schematic for a slightly modified JDM PIC
    programmer which I just finished building. Unfortunately using it with
    IC Prog did not yield good results- even though Vdd and MCLR voltages
    are present, I am only getting blank data when trying to read/write a
    16F84A chip.

    * What other signals should I be checking and what are the expected
    values ?

    * What are reliable settings in IC Prog ?

    * Does the schematic look correct? I compared it with the original
    design and noticed a 2.2k instead of 1.5k resistor and the transistors
    are different, though they seem to have similar specs :
    http://img218.imageshack.us/img218/633/jdmro1.png

    Thank you!
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-