Connect with us

is some kind of configuration required for HC05 bluetooth module ,when using it for the first time?

Reply to Thread

Discussion in 'Microcontrollers, Programming and IoT' started by LORD PHOENIX, May 30, 2014.

Scroll to continue with content
  1. May 30, 2014 #1
    LORD PHOENIX

    LORD PHOENIX

    5
    0
    May 27, 2014
  2. Jun 2, 2014 #2
    shumifan50

    shumifan50

    579
    57
    Jan 16, 2014
    As far as I can see the key pin is just to ensure the plug is plugged in correctly,

    You will need to configure the UART on the bluetooth module for speed/parity/stopbits/databits or configure the UART on the Arduino to match default settings on the bluetooth module. Also remember the TX of the Arduino UART goes to the RX of the bluetooth and vice versa. Make sure you don't reverse the polarity of the power to the module.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. (Open for advices) using the nrf52832 module MDBT42Q

  2. Is it possible to use barometer module using UARTS?

  3. Bluetooth module connection detection

  4. Configuration of LCD Screen for raspberry pi 3

  5. PIC interfacing with Bluetooth module

  6. Using Algorithm Builder for your first ATTiny13 Atmel project

  7. Interfacing bluetooth module with microcontroller

  8. Arduino about HC05

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-