Connect with us

Is my connection on my touch sensor correct?

Discussion in 'General Electronics Discussion' started by blueyblubber, Jan 14, 2019.

Scroll to continue with content
  1. blueyblubber

    blueyblubber

    1
    0
    Jan 14, 2019
    I made a breakout board for the touch sensor to connect to my arduino. In short, the sensor should spew out X,Y coordinates via I2C. But I have some questions regarding the connections.
    Datasheet here: https://drive.google.com/file/d/1sqVsPIXbH_-TgMKM20TwqdT8hT_Vp-zJ/view?usp=sharing
    [​IMG]
    https://imgur.com/a/zkxRxCn

    I would like to confirm Pins 1, 8, 10, 12 and 14. What I did was:
    Pin 1 = Arduino GND (same with pin 5)
    Pin 8 = 3.3V
    Pin 10 = Arduino GND (same with pin 5)
    Pin 12 = 3.3V until button press to 0V
    Pin 14 = 3.3V until button press to 0V

    Any help would be appreciated! I almost got it working! Thank you all in advance!
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-