Connect with us

IR Transmitter

Discussion in 'Electronic Basics' started by Indra Suryanata, Nov 23, 2004.

Scroll to continue with content
  1. I am a complete beginner. I just bought the Proton Dev Board MKII plus
    LCD (http://www.picbasic.org/proton_dev.php).

    I would like to create an IR Transmitter/remote control for my Sony
    DVD Player (DVP-NS575P) to get started. If I would like to make button
    1 on the board to send "Play" and button 2 to "Stop", how do you code
    them in PIC BASIC?

    I am using Proton Lite right now and has ordered Proton Development
    Suite.

    Thanks so much for your help.

    Best regards,

    Indra
     

  2. Unless someone has the control codes for your DVD player, your best bet
    would be to build an IR *receiver* first. Then aim your DVD remote
    at it, press 'play,' and record the ?30? bits of data plus the pulse
    width timing.
     
  3. Colubris

    Colubris Guest

    Hi Indra,
    Have you tried the user forums at picbasic.org? There is also a
    searchable mailing list archive at www.melabs.com

    I've seen several discussions on very similar topics in the past.
     
  4. Wong

    Wong Guest

    An extra IR Receiver might not necessary. Just open your DVD remote
    case, use your oscilloscope to probe the signal. You would have to
    understand the protocol of the remote using. From there, 'decode' the
    signal from the oscilloscope yourself.
     

  5. Thanks a lot for everyone who responded.
    I really appreciate it.

    I have tried the user forums at picbasic.org, but no responses.

    Anyway, I will try all your suggestions.
    Thanks again.

    Indra
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-