Connect with us

Interpreting diagnostics on Tek 2710 Spectrum Analyzer

Discussion in 'Electronic Equipment' started by Graham Hill, Jul 28, 2005.

Scroll to continue with content
  1. Graham Hill

    Graham Hill Guest

    I have a Tek 2710 Spectrum Analyzer that has several faults, its main
    error message is
    "cannot count (VCO,IF)"
    I have the manual but it is virtually useless on interpreting the
    firmware diagnostics routines, does anyone know this message, there
    are at least 3 VCOs and 3 IFs, worst case scenario is probably a bad
    YIG but the diagnostics should be able to narrow the possibilities a
    bit more for me
    Graham (remove the ham from my address)
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-