N
N Cook
- Jan 1, 1970
- 0
Anyone have any advice beyond just rattling connectors , contacts,
components etc with a bit of plastic pen barrel., plus hot air gun heating /
running amp into dummy load?
Engraving tool with the steel tip replaced with something plastic.?
Setting the whole cabinet on a motor driven offset cam ? if so what revs/sec
range ?
components etc with a bit of plastic pen barrel., plus hot air gun heating /
running amp into dummy load?
Engraving tool with the steel tip replaced with something plastic.?
Setting the whole cabinet on a motor driven offset cam ? if so what revs/sec
range ?