Infocus LP250 Wont Start.

[[email protected]]

Hi.

My english is not verry good so i hope you understand me.

I have one Infocus LP250 that wont start.
Is ther anyone out ther that have any clue what it can be?
It seams to be a quit usual problem on this model?
I think the problem is in the power unit but im not sure.

Best Regards
Tobias

 

[jango2]

Does the standby indicator glow?
The chameleon power l.e.d. reports the state of the unit.

"solid green: The projector is plugged in, or the projector has been
turned on and the
software has initialized. The projector has been turned off and the
fans have stopped.

blinking green: The Power button has been pressed and the software is
initializing, or the
projector is powering down and the fans are running to cool the lamp.

blinking red: A fan or lamp failure has occurred. Make sure the vents
aren't blocked. Turn off the projector and wait one minute, then turn
the projector on again. If the projector
has been working for 2000 hours or more, replace the lamp and reset the
lamp timer by pressing Volume +, then Volume -.

solid red: An unidentifiable error: please contact Technical Support."

Which of the above four modes does the l.e.d. report?
Jango