Connect with us

IEC socket punch

Discussion in 'Hobby Electronics' started by Trevor Wilson, Jun 4, 2005.

Scroll to continue with content
  1. Any ideas on a source for an IEC socket punch for steel chassis? RS
    Components have them, but at horrendous cost.
     
  2. **That would option #2.
     
  3. Ken Taylor

    Ken Taylor Guest

    IIRC many years back we bought one from AllTools.

    Ken
     
  4. Mark Harriss

    Mark Harriss Guest


    I see most computer power supplies have a rectangular
    hole which the IEC chassis connector covers fully.
    About 22 x 27 mm in size. That'd be about 7/8" by 1&
    1/8" approximately: is there a punch that size?.
     
  5. Mark Harriss

    Mark Harriss Guest


    Bugger: $325 for a punch!!, I was planning to make
    one for a lever press at some stage but then I have
    access to a friend who made dies for a living once
    so I can use his expertise.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-