Connect with us

IC Adapters

Discussion in 'General Electronics' started by prizark, Jan 16, 2004.

  1. prizark

    prizark Guest

    Hi guys,

    I recently got some 64pin/TQPF chips and I want to try out some
    experiments on my bread board before going any further.But as we are
    aware that the breadboard can only take DIP based IC.I would like to
    know of other possible solutions to use non-DIP IC's,i.e. to convert
    them to DIP.I searched the net and found some programming adapters but
    they all cost a fortune, something like $220US for a single 64pin/TQPF
    to DIP adapter.I was thinking of getting good quality PCB's and have a
    TQPF socket on one side and DIP pins on the other site for moutin
    purposes.Please suggest some soluttions to my problem.


    Thank You,
    Prizark
     
  2. scada

    scada Guest

    www.jameco.com has some breadboard addapters for smt, plcc, etc.
     
  3. HaCv

    HaCv Guest

    I had the same problem with a 48pins/LQFP and the quickest solution i
    found, was making the adapter for the breadboard by myself using
    protel, take about 1 1/2 hours since you start the design until you
    solder the chip.
    What was that "programming adapters"? that cost 220$?? i don´t get it,
    why so much investment for so simple task.
     
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-