Connect with us

I2C interface HELP

Discussion in 'Microcontrollers, Programming and IoT' started by lmoraxs, Nov 19, 2009.

Scroll to continue with content
  1. lmoraxs

    lmoraxs

    1
    0
    Nov 19, 2009
    I am trying to interface a MASTER PIC with a SLAVE PIC using PIC18F2420 for both master and slave. I have played around with my code so much but when i simulate it i dont seem to get the results i expect. I have used the header files provided by microchips MCC18 compiler for the pic and I2c. I am trying to write a very simple program for the master pic telling the slave pic to output a string of zero's and one's that will light up LED's accordingly. The source code is given below:

    #include <p18f2420.h>
    #include <I2c.h>
    #define SLAVE_7_STSP_INT 0b00001110
    #pragma config OSC = INTIO67

    //unsigned char counter;
    void initialisePorts (void)
    {
    TRISC = 0b10011000; //I2c bits set

    }
    void main (void)
    {
    OpenI2C ( MASTER, SLEW_ON ); //intialise 12C
    SSPADD = 0x63; // set up baud rate


    StartI2C (); //send start condition
    WriteI2C (SLAVE_7_STSP_INT); // write to address (slave pic)
    while (1) {
    //I2C_SDA
    //I2C_SDA


    //for (counter = 0; counter <= 10; counter++)
    WriteI2C ();

    TRISCbits.TRISC4 = 0b11111111; //output to SDA
    TRISCbits.TRISC4 = 0b10000001;

    }



    StopI2C ();
    }

    Can anyone please show me wher i am going wrong. My ultimate aim is to interface a SE95 temperatue sensor with the master pic via the i2c bus but i belive once i can get this to work that should be easy. Thank you.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-