Connect with us

HP8012B Pulse Generator

Discussion in 'Troubleshooting and Repair' started by KiwiSteve, Jan 3, 2017.

Scroll to continue with content
  1. KiwiSteve

    KiwiSteve

    28
    0
    Apr 11, 2014
    Hello,

    Does anyone have experience repairing an HP8012B pulse generator? I'm looking for some help fixing one.

    Thanks,
    Steve
     
  2. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,499
    2,839
    Jan 21, 2010
    Do you have the service manual?
     
  3. 73's de Edd

    73's de Edd

    3,145
    1,322
    Aug 21, 2015
    Sir KiwiSteve . . . . .

    Haven't used that one since the 90's . . . . .expound upon your problems being experienced with it.

    Here is its DA--DA book:

    Hoolet Plastered 8012 MANUAL
    http://bama.edebris.com/manuals/hp/8012b/


    73's de Edd
     
    Last edited by a moderator: Jan 4, 2017
  4. KiwiSteve

    KiwiSteve

    28
    0
    Apr 11, 2014
    Thanks for the reply.

    Basically, I purchased a "fully functional" unit on ebay that turned out to be DOA. On inspection there is a red wire and purple wire coming off the transformer at the rear of the unit. Both wires appear to have been cut, or possibly have become disconnected from some other place. I do have a manual and have looked at the schematics but haven't taken too much time to figure out the fault.

    Steve
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-