Connect with us

HP Pulse Generator 8160A

Discussion in 'Electronic Repair' started by Peter Werzer, Oct 3, 2005.

Scroll to continue with content
  1. Peter Werzer

    Peter Werzer Guest

    Hey,

    I have a puls generator mentioned above.

    The settings for the impuls frequency and width and so
    on work fine but there is a problem.
    If I set the the impedance on 10kOhms I
    only get 4V amplitude instead of 19.99V and at 50 Ohm there is
    only 200mV instead of 9.99V. I have not found anything to change
    this behavior! Also there is shown an error message "PARAM" if I press
    the High Level (HIL) botton or the Low Level (LOL)
    botton.
    The DC-voltage is on the 0-line at about -7.5V and
    oscillate 300mV up and down.

    If there is someone who knows what is wrong please let me know!

    best regards
    Peter
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-