mrbreezeet1
- Dec 28, 2014
- 3
- Joined
- Dec 28, 2014
- Messages
- 3
I have this board, model KK6039T motor control, and was not mindful when I took the treadmill apart.
I want to use the motor and board in my shop, and wonder if you could help me wire it.
I see
S1 S2 and S3 in this one picture I found goes to the pot.
Do you know what one is the center wiper?
OK, then there is L1 and L2
and A1 and A2
does anyone know what they are?
Two I take it are, AC in, Two i take it is the motor hook up, but I didn't pay attention when I took them out of the treadmill.
Thanks, Tony
I want to use the motor and board in my shop, and wonder if you could help me wire it.
I see
S1 S2 and S3 in this one picture I found goes to the pot.
Do you know what one is the center wiper?
OK, then there is L1 and L2
and A1 and A2
does anyone know what they are?
Two I take it are, AC in, Two i take it is the motor hook up, but I didn't pay attention when I took them out of the treadmill.
Thanks, Tony