Hello all,
Fan has a single 3-pin connector (Yellow, Red, Black wires). It connects to the FAN1 plug in the control board (on the left side of the image marked with Y-R-B). Yello signal/sense wire is supplying the control board rpm.
What do i need to do to make the control board to think it is always spinning without running the fan?
The purpose is to make Zalman Reserator XT run without a fan.
PS: Not a motherboard or BIOS question. Temperatures no problem.
Thank you in advance for your time.
Maria
Image courtesy of PC Perspective.
Fan has a single 3-pin connector (Yellow, Red, Black wires). It connects to the FAN1 plug in the control board (on the left side of the image marked with Y-R-B). Yello signal/sense wire is supplying the control board rpm.
What do i need to do to make the control board to think it is always spinning without running the fan?
The purpose is to make Zalman Reserator XT run without a fan.
PS: Not a motherboard or BIOS question. Temperatures no problem.
Thank you in advance for your time.
Maria
Image courtesy of PC Perspective.