Connect with us

how to check if there is proper connection...

Reply to Thread

Discussion in 'General Electronics Discussion' started by dtvonly, Nov 20, 2013.

Scroll to continue with content
  1. Nov 20, 2013 #1
    dtvonly

    dtvonly

    11
    0
    Mar 14, 2012
    I have PCBs that I need to test by placing the PCBs test points on pogo pins. But before I run the test, I want to know that all connections had been made. How can this be done?
     
  2. Nov 21, 2013 #2
    davenn

    davenn Moderator

    13,765
    1,920
    Sep 5, 2009
    initially you would need a test jig ( that has the spring contacts) that the board fits into snuggly ( semi tight) so that it automatically lines up the pins with the testpoint pads on the PCB

    so ...
    1) the jig is a semi tight fit so the PCB cannot move back and forward
    2) you could also use a couple of screw mounts to screw the board down
    this provides vertical stability so the PCB contact pads sit down against the test pins

    Dave
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Check if schematic is correct

  2. Best way to check if micro-USB connector is soldered correctly?

  3. How to select proper rating fuse!!

  4. How to tell if a switch is a good one?

  5. how to check for an open resistor?

  6. How to choose and where to get proper electronic fuses

  7. How Ground Plane to Chassis GND connection?

  8. Ideas to check continuity

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-