Connect with us

How to build a taser gun?

Discussion in 'Electronic Basics' started by Gerry Lintonice, Sep 26, 2005.

Scroll to continue with content
  1. Some asshole-cops got me with their tasers yesterday.OUCH.

    Now I want revenge and fry their fat, donut-filled butts.

    How can I build a taser to fry fat and ugly cops?
     
  2. Impmon

    Impmon Guest

    Step one: learn how to make a shrinking ray

    Step 2: build a Telsa coil with Jacob's Ladder on top.

    Step tres: shrink that one

    Step D: make sure you're holding the right end when you try to zap
    someone.

    Seriously if they zapped you, you probably deserved it like refused to
    obey cops or showed dangerous postures.
     
  3. jm

    jm Guest

    Hmm - "fat ugly cops" as opposed to what? Burly good looking? Sounds like
    you "do" have a preference in cops! They don't use those things unless you
    asked for it. Disobey a cop and they will use that or mace. That is their
    first line of defense since they're not allowed to just shoot "ass holes".

    As another poster said - most likely you refused to obey. GOOD FOR YA. IF
    you even remotely think of getting even with them, the next time they shoot,
    could bury your ass...... Oh well!!!!!!!!!!
     
  4. Nog

    Nog Guest

    Just put a furnace ignitor, an inverter and a small 12 volt battery, duct
    tape them together and place in backback. Attach leads to ignitor with
    probes on the other end. Now go zap somebody.
     
  5. jm

    jm Guest

    Leave some wires hanging out too while you're at it - being part will no
    doubt be in a back or fanny pack of some sort, so someone can mistake your
    device for a bomb. That will entice the cops you seek - to show up. Then
    when you defy them again, maybe they'll smoke your ass.
     
  6. Tom Biasi

    Tom Biasi Guest

    Don't feed this guy. He is know to UseNet as the anagram troll.
    His nics are anagrams like Gerry Lintonice - nitroglycerine.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-