Connect with us

How do I use SOIC chips?

Discussion in 'Electronic Basics' started by Metalicat, Nov 24, 2005.

Scroll to continue with content
  1. Metalicat

    Metalicat Guest

    Hi. I have some SOIC-chips, but I don't know how to use them.

    How can I solder those small ICs onto a board? Is there any good techniques
    I should know of?
    Thanks is advance.

    - Jan Rune -
     
  2. ehsjr

    ehsjr Guest

    see
    http://www.alltronics.com/surfboards.htm
     
  3. Bob Monsen

    Bob Monsen Guest

    Try these:

    http://www.futurlec.com/SMD_Adapters.shtml

    --
    ---
    Regards,
    Bob Monsen

    Mathematics compares the most diverse phenomena and discovers the secret
    analogies that unite them.
    - Joseph Fourier
     
  4. notme

    notme Guest

    SOIC is very easy to use if you have a board with the appropriate pads on
    it. Simply put the chip in the appropriate place on the board. Put a
    little flux on the pin/pads. Wet the tip of the iron with solder. Then
    hold the part in the appropriate location with a pair of tweezers and with
    the other hand touch some of the outer pins. This should virtually
    instantly solder them and hold it in place so you no longer need the
    tweezers. Re-wet the iron and then go down the rows and solder the other
    pins. The amount of solder on the iron itself should be adequate to
    solder them, you do not need to actually bring the solder in contact with
    the pins. The key here is to have good equipment.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-