Maker Pro
Maker Pro

How can I connect a remote controlled switch board to a motor ?

dxr346

Aug 1, 2012
1
Joined
Aug 1, 2012
Messages
1
:confused:I’m not too familiar with electronics. How can I connect a remote controlled switch board to a motor ? I have attached a pic of the switch board. When I press the remote, I want the motor to rotate 180 degrees in one direction and stop. Then when I press the remote the second time it should turn 180 degrees in the opposite direction and stop. Basically, I want to connect the end of the motor to an iron rod ( the size of a ballpoint pen ) that will act as a simple lock that will jam a door.

There are commercially available remote door locks, but they cost a fortune.
 

Attachments

  • remote.jpg
    remote.jpg
    39.5 KB · Views: 138
Top