Maker Pro
Maker Pro

Host interface

A

Ant_Magma

Jan 1, 1970
0
I've previously ask this question however i did not get a reply.

I have a module that interfaces using;
1) MII PHY
2) GPSI PHY
3) MII Host/DTE

I've searched typical Ethernet transceivers to communicate using the
MII PHY. However, the Ethernet interface circuit is taking for too long
to build.

I was wondering can i use the simple RS232?
 
P

PeteS

Jan 1, 1970
0
Ant_Magma said:
I've previously ask this question however i did not get a reply.

I have a module that interfaces using;
1) MII PHY
2) GPSI PHY
3) MII Host/DTE

I've searched typical Ethernet transceivers to communicate using the
MII PHY. However, the Ethernet interface circuit is taking for too long
to build.

I was wondering can i use the simple RS232?

I seem to remember replying - my apologies, I was netless for a few
days.

The short answer is you do not have (listed above) a RS232 interface.
You have an ethernet (802.3 actually) interface. There may be a serial
port on the unit.

What is the device?

Cheers

PeteS
 
P

PeteS

Jan 1, 1970
0
Ant_Magma said:
I keep thinking RS232 is possible because i'm confused with the MII
Host/DTE.

It's a Belfuse 0804-5000-03 Powerline networking module

http://belfuse.com/ProdList-Cable-H...werline Modules&pReset=y&pOrder=BelPartNumber

I'm just trying to c what other options i have if i cant make the
ethernet transceiver work in time. I've ordered DP83847 but i haven't
got them yet.

I took a look at the device and your only option to make it work is to
have a host interface to control it (and that's a host interface that
knows how to control an ethernet device via the usual methods). One
option is to get a MII compatible PHY and configure it across ethernet,

Cheers

PeteS
 
Top