Maker Pro
Maker Pro

Holes in Plates

R

Richard Henry

Jan 1, 1970
0
Jim Thompson said:
Ah, I see. Keep the supports from sending back stuff that gets past
the suppressor grid??

I remember the suppressor grid from my Navy electronics school tube-section
final exam. The correct answer is D: all of the above.
 
E

ehsjr

Jan 1, 1970
0
Rich said:
Since we're all guessing, I'm going with thermal stress relief. :)

Or, since the plates are made of a special alloy of mysterium and
unobtanium, it's to save material to make more anodes with - maybe
they use the little circles to make nuvistors!

Cheers!
Rich

Rich,

Actually, the answer is in your post in another thread, where
you mentioned a degausser. The holes in the tubes mentioned
in the post are ... degassers!

Ed
 
Top