Connect with us

High Voltage cables

Discussion in 'General Electronics Discussion' started by masudasim, Oct 4, 2012.

  1. masudasim

    masudasim

    6
    0
    Aug 25, 2012
    Hello all

    I need to select/source suitable shielded conductor/cable (of 200m lenght) for carrying 2 KVrms sinewave signal of 2 KHz frequency. The current will not exceede from 1.5 amp.

    Moreover 2 to 4 conductor pairs will be placed side by side so shielding required for as less interfarence as possible.

    Can any one kindly help me for selecting suitable cable/conductor?

    Best Regards
    asim
     
  2. duke37

    duke37

    5,255
    726
    Jan 9, 2011
    You could look at RF co-axial cable. Anything with a diameter of over 0.25 inch would seem to be able to withstand your voltage. RG8 is a common variety used by hams, this has a limit of 4kV. There are many others.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-