Connect with us

HHD6-G PWM power supply

Reply to Thread

Discussion in 'Power Electronics' started by Willi Hersch, Dec 21, 2020.

Scroll to continue with content
  1. Dec 21, 2020 #1
    Willi Hersch

    Willi Hersch

    2
    0
    Dec 21, 2020
    I am using an HHD6-G PWM power supply for a lathe motor. It seems to work, but the output looks quite amazing I was expecting a regular series of rectangular pulses. Does this look normal? Thank you HHD6-G.jpg
     
  2. Dec 21, 2020 #2
    Bluejets

    Bluejets

    4,424
    938
    Oct 5, 2014
    What is the motor...??
     
  3. Dec 21, 2020 #3
    Willi Hersch

    Willi Hersch

    2
    0
    Dec 21, 2020
    That is the picture of the output when it is not attached to the motor. Will it make a difference?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Alternatives to pwm power supply

  2. Help : PWM generation

  3. PWM Online Battery Charger

  4. PSU Silverstone ET550-G dead after thunderstorm (turned itself off)

  5. Converting a PWM wave into pure DC

  6. PWM issues when powering 4pin 12v fan without a motherboard

  7. Need help figuring out PWM output through a Mosfet

  8. Can this PWM the amp burst ourput in this Nerf setup?

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-