Connect with us

HELP with Schematics for magnet launcher

Discussion in 'General Electronics Discussion' started by CLD, Jul 9, 2019.

Thread Status:
Not open for further replies.
  1. CLD

    CLD

    2
    0
    Jul 9, 2019
    I am recreating the induction launcher in this YouTube vid:

    I have all of the parts:
    2 tranformers
    4 resistors
    bridge rectifier
    4 capacitors
    SCR
    Switch
    Electromagnet coil

    I don't know how to read the schematics - HOW do I connect all of the parts and where for each?

    Get back to me so we can talk about it.
    Thanks

    IT WONT ALLOW METO UPLOAD PICS!!!!
     
  2. Bluejets

    Bluejets

    3,512
    710
    Oct 5, 2014
    It is an accepted fact that capital letters and exclamation marks are considered as shouting which no one appreciates and will normally get you very little of your intended attention.
    It is also obvious the link did not upload either.
     
    davenn likes this.
  3. davenn

    davenn Moderator

    13,315
    1,766
    Sep 5, 2009
    your image was probably too big (physically)
    make sure images are .jpg and less than 1024 x 768, preferably ~ 800x600 and 100kb or less
     
  4. Nanren888

    Nanren888

    120
    24
    Nov 8, 2015
    Link to video?
    Google "how to read electrical schematics"?
    I got a youtube video and a sparkfun page plus lots of others.
     
  5. Alec_t

    Alec_t

    2,691
    712
    Jul 7, 2015
    If it's the same circuit you were considering over at AAC, it's potentially lethal nature has already been pointed out! It would likely infringe the Terms and Conditions of this site.
     
    OBW0549, hexreader and davenn like this.
  6. Audioguru

    Audioguru

    2,605
    586
    Sep 24, 2016
    The noob thinks the random parts he bought will not explode or set his house on fire!
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Thread Status:
Not open for further replies.
Electronics Point Logo
Continue to site
Quote of the day

-