Maker Pro
Maker Pro

Help with Inductive Sensor.

I'm trying to connect a 3-wire NPN inductive sensor, 10 to 30v, and I
need to get a 5v output. If someone has an idea on how to do that or a
schematic showing how to wire it.

If possible email me at [email protected]

Thank you for your help.
 
M

martin griffith

Jan 1, 1970
0
On 26 Apr 2006 16:38:14 -0700, in sci.electronics.design
I'm trying to connect a 3-wire NPN inductive sensor, 10 to 30v, and I
need to get a 5v output. If someone has an idea on how to do that or a
schematic showing how to wire it.

If possible email me at [email protected]

Thank you for your help.
Nope, post message here, read message here


martin
 
L

Luhan

Jan 1, 1970
0
I'm trying to connect a 3-wire NPN inductive sensor, 10 to 30v, and I
need to get a 5v output. If someone has an idea on how to do that or a
schematic showing how to wire it.

The NPN specification on a sensor often means that the output is
open-collector and pulls to ground. This can drive any 5 volt logic
circuit with a simple pull-up resistor to +5 volts.

Luhan Monat (luhanxmonat-at-yahoo^dot^com)
http://members.cox.net/berniekm/
"Reality: what a concept!"
 
Top