Connect with us

Help me with bipolar stepper motor..

Reply to Thread

Discussion in 'Sensors and Actuators' started by bashok001, Jun 18, 2009.

Scroll to continue with content
  1. Jun 18, 2009 #1
    bashok001

    bashok001

    1
    0
    Jun 18, 2009
    I am devising a knock lock for which i used a bipolar stepper motor using a mosfet driver..I have four terminals coming out of motors! I connected them all with four mosfets...Now it doesn't move...so I did a small research on internet on bipolar stepper motor drivers and i got these circuit diagrams in which they connected the motor with MC driver as I did but the coils are also coonected to 12 v from their middle...
    From where should this connection be made..??? We have four terminals coming out of motor which are all already engaged completely... So how will this 12v battery connection to motor made?
     
  2. Jul 31, 2009 #2
    Resqueline

    Resqueline

    2,848
    2
    Jul 31, 2009
    You'll need 4 half-bridge outputs, 8 transistors in all, to make 2 full-bridge drivers to drive that motor. The top 4 transistors would be connected to +12V. Granted, it's a little more complex than using a 6-wire motor.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. bipolar stepper motor to parallel port

  2. Bipolar Stepper Troubleshooting need help.....

  3. Stepper Motor Help

  4. Help with a stepper motor IC

  5. stepper motor

  6. Stepper motor

  7. [Need help] Stepper motor control

  8. Help with wireless stepper motor and LCD project

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-