Connect with us

[HELP] 7Amp 12vdc Heater controlling with PWM & MOSFET

Reply to Thread

Discussion in 'Microcontrollers, Programming and IoT' started by Boo123, Apr 9, 2019.

Scroll to continue with content
  1. Apr 9, 2019 #1
    Boo123

    Boo123

    1
    0
    Apr 9, 2019
    Hello everyone,

    I'm working on a project that controls 12Vdc 7Amp silicon heater pad using MOSFET.
    I tried HA210N06 MOSFET with a heatsink but it doesn't work correctly, the heater doesn't get hot but the MOSFET is getting very hot, I tried another lower amper heater it's work but also not get very hot with a 100% duty cycle as I connect it directly to the power supply.

    I'm using dual output power supply 5v for microcontroller and 12v 15A for the heater.
    PWM frequency is 500hz.
    I'm using pic 18f4685 and programming with MikroC.

    The circuit is attached.

    my question is this MOSFET could work correctly but I have some connections problem or coding problem?

    Thank you.
     

    Attached Files:

  2. Apr 10, 2019 #2
    Bluejets

    Bluejets

    4,427
    938
    Oct 5, 2014
    Use a logic level mosfet.

    Easy to identify by the use of "L" in the prefix.
    An example would be IRLZ44n.
    Also run a 10K resistor from gate to ground to make sure the mosfet turns off.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Arduino restarting while controlling a mosfet with PWM.

  2. design buck converter with arduino controlling pwm

  3. Logic mosfet pwm

  4. Help with TL494 PWM

  5. Help with a camera controlling sequence

  6. Controlling Atmega328 with router

  7. Controlling High Currents with Microcontroller

  8. New but asking for help with MC / PWM ?

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-