Header Jumper Wire

[[email protected]]

Does anyone know where to get some wire jumpers for 0.1mm headers? I
do a lot of board to board connections with header pins. These change
based on FPGA routing so I don't wire wrap. They need to be quickly
connected. I've searched and haven't had much luck. The only thing I
found were these: http://www.basicx.com/Products/Jumpers/jumper.htm

Those would work, but I have some that have nice shrink warpped ends.
I don't know where they came from. Perhaps someone at the company made
them long ago!

Thanks!

 

[[email protected]]

Does anyone know where to get some wire jumpers for 0.1mm headers? I
do a lot of board to board connections with header pins. These change
based on FPGA routing so I don't wire wrap. They need to be quickly
connected. I've searched and haven't had much luck. The only thing I
found were these: http://www.basicx.com/Products/Jumpers/jumper.htm

Those would work, but I have some that have nice shrink warpped ends.
I don't know where they came from. Perhaps someone at the company made
them long ago!

Thanks!

I meant 1mm pins!!

 

[mc]

For 0.1"-spacing headers, do you mean?

What I do is crimp the appropriate connectors onto the ends of #22 stranded
wire, then shrink some heat-shrink tubing onto them.

We are lucky that someone gave us some AMP crimping pliers that originally
cost $500 and are beautifully precise. But it is not hard to get good
results with a much cheaper crimping tool.