Connect with us

Hantek 5102

Discussion in 'General Electronics Discussion' started by Gregory Harding, Jul 18, 2016.

Scroll to continue with content
  1. Gregory Harding

    Gregory Harding

    1
    0
    Jul 18, 2016
    With signals on both channels, how can I measure both channels without turning one channel off?
     
  2. Amar Dhore

    Amar Dhore

    129
    12
    Dec 2, 2015
    You can use a Mux.
     
  3. hevans1944

    hevans1944 Hop - AC8NS

    4,626
    2,159
    Jun 21, 2012
    Simple, you just apply a signal discriminator to the signals in both channels and measure whatever you please.
     
  4. Sunnysky

    Sunnysky

    488
    126
    Jul 15, 2016
    is this a procedural question on DSO?

    I rarely do, but when in doubt RTFM read the fine manual.
    ...snip
    Push the MEASURE button to perform auto measurements. There are 32 types of measurements and up to 8 can be displayed at a time. Turn the V0 knob to select an unspecified option. Press V0 or F6 when the red arrow icon stops on it. Then the following menu appears.
     
    Last edited: Jul 19, 2016
    hevans1944 likes this.
  5. hevans1944

    hevans1944 Hop - AC8NS

    4,626
    2,159
    Jun 21, 2012
    When my new Hantek DSO 5202P gets too confusing, I just swap the test leads over to my ancient Tektronix 465B... losing the waveform storage ability of course. And the math functions. And the USB computer interface. And maybe some brightness of the trace if the sweep speed is very fast. Hmm. I knew there was a reason I shelled out big bux for a new 'scope. Maybe I should spend some time to RTFM too. :rolleyes:

    There's a nice review of the Hantek DSO 5102B here.
     
    Last edited: Jul 19, 2016
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-