Connect with us

Front end for Spectrum Analyser

Discussion in 'Electronic Equipment' started by Zilog, Dec 13, 2006.

Scroll to continue with content
  1. Zilog

    Zilog Guest

    Hi,
    I have a spectrum analyser (Siemens K2001)but alaas it's only for a
    limited band (200Hz to 4200Hz)
    I intend to use it for low frequencies Up to 100KHz.
    My question is it done in commercial Spectrum analysers to shift the to
    measure frequencies (in this case about 4KHz to 100KHz) to the
    measurable range of the instrument (in this case 200Hz to 4200Hz)
    Can I expect to have a decent resolution and sensitvity?
    Thanks,
    Zilog
     
  2. Robert Baer

    Robert Baer Guest

    Earthlink NGs have been *DEAD* for about a week and a call to their
    so-called customer service (which is outsourced) is a total waste of time.
    It is not easy to get them to talk about the NG server problem, and
    then they lie saying that "it will be fixed momentarily".
    Call any day you want, and that is all you can get.
    Nevermind that they supposedly had *THREE* independent servers, they
    have gone down one at a time to never be restored.
    Perhaps it is time to demand a refund for services not rendered.
     
  3. Zilog

    Zilog Guest

    Hi Robert,
    Euh, Wht is the link between Earthlink NGs and my Question?
    Zilog
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-