Maker Pro
Maker Pro

Friden STW Calculator-locked up

D

Dave_s

Jan 1, 1970
0
A friend has a beautiful old Friden model STW Calculator that stopped
working, "top is locked up" is his description. We are looking for a
person, group, society, etc in Southern California to assist.
Is it possible the machine just broke a belt? Is it possible to try a
DIY repair if parts are available? Thanks for any hints. Dave_S
 
N

NSM

Jan 1, 1970
0
Dave_s said:
A friend has a beautiful old Friden model STW Calculator that stopped
working, "top is locked up" is his description. We are looking for a
person, group, society, etc in Southern California to assist.
Is it possible the machine just broke a belt? Is it possible to try a
DIY repair if parts are available? Thanks for any hints. Dave_S

http://www.oldcalculatormuseum.com/fridenstw.html

Try to find a typewriter repair shop. They may be able to suggest fixes. An
old time tube radio repairman could probably fix it also.
 
S

Sam Goldwasser

Jan 1, 1970
0
NSM said:
http://www.oldcalculatormuseum.com/fridenstw.html

Try to find a typewriter repair shop. They may be able to suggest fixes. An
old time tube radio repairman could probably fix it also.

With a mechanical calcuating machine, especially one as complex as those,
it's quite likely that the first step is a good cleaning. You're talking
about 50 year old oil, grease, dirt, grime, and gunk. :)

I have one like that I haven't tried in years that sort of worked. I had
another one that was locked up and I sold to someone who was going to
restore it but I never learned of the outcome.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.
 
N

NSM

Jan 1, 1970
0
With a mechanical calcuating machine, especially one as complex as those,
it's quite likely that the first step is a good cleaning. You're talking
about 50 year old oil, grease, dirt, grime, and gunk. :)

I have one like that I haven't tried in years that sort of worked. I had
another one that was locked up and I sold to someone who was going to
restore it but I never learned of the outcome.

I'd probably start with toothbrushes and kerosene, then move on to
lubrication.
 
Top