D
David McCarroll
- Jan 1, 1970
- 0
I have a fluorescnet light fixed in a new industrial paint booth
application. The data plate says 277 VAC .43AMP 110VAC .9AMP. On the
system I have 480V 3phae 60Hz with a neutral. When I measure from one
phase to neutral I get ~270V. If I hook one phase and neutral to the
balast wiring will this give me the proper voltage that is needed to
operate the light fixture? I do not have 110VAC available, with out
running new wires.
Any help with this would be greatly appriciated.
application. The data plate says 277 VAC .43AMP 110VAC .9AMP. On the
system I have 480V 3phae 60Hz with a neutral. When I measure from one
phase to neutral I get ~270V. If I hook one phase and neutral to the
balast wiring will this give me the proper voltage that is needed to
operate the light fixture? I do not have 110VAC available, with out
running new wires.
Any help with this would be greatly appriciated.