Connect with us

flatscreen monitor

Discussion in 'Electronic Repair' started by Humbled Survivor, Jul 23, 2013.

Scroll to continue with content
  1. This is in respect to a hp vs17c computer monitor.

    It broke. Nothing.

    4 years later I tore it apart and replaced 3 popped capacitors on the power
    supply board.

    Then it worked, but for only about 10 seconds. Then it flickers and goes
    dead again.

    The old capacitors were 10v 1000uf. The new ones I put in were 35v 1000uf.
    Would that make any difference?

    There is one other unpopped capacitor in the vicinity. I haven't replaced
    it yet, but I can't figure anything else out. Maybe I am going to have to
    buy a whole new power supply board?
     
  2. N_Cook

    N_Cook Guest


    repeated 10s or one-off?
     
  3. 2 sec. and off.

    I tore it apart again, tightened a loose connector and now it works like a
    charm. I guess the three $1.99 capacitors from Radio shack work for the
    time being. I guess my soldering was ok as well. I saw how the guy
    repaired them on U-Tube. I found 3 popped capacitors and replaced them.
    Now it works. Now my girlfriend has her old flatscreen back. That might be
    worth rolling a carton of cigarettes.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-