Maker Pro
Maker Pro

Flash Problem bei Fujitsu Controller MB90F562

F

FranzM

Jan 1, 1970
0
Hallo NG,

beim Test des Fujitsu Controllers MB90F562 tritt bei mir das Problem
auf, dass immer wieder der Pin26 (P01), der zum Flashen benötigt wird,
abraucht, ohne dass der Pin im Test überhaupt berührt wird. Ist
jemandem ein ähnliches Problem bekannt? Ist dieser Pin aufgrund des
inneren Aufbaus des Controllers besonders zerstörungsgefährdet?
 
A

Al

Jan 1, 1970
0
Hallo NG,

beim Test des Fujitsu Controllers MB90F562 tritt bei mir das Problem
auf, dass immer wieder der Pin26 (P01), der zum Flashen benötigt wird,
abraucht, ohne dass der Pin im Test überhaupt berührt wird. Ist
jemandem ein ähnliches Problem bekannt? Ist dieser Pin aufgrund des
inneren Aufbaus des Controllers besonders zerstörungsgefährdet?

Ich weiss nicht. Ubersetzen Sie auf english, bitte.

Al
 
Al said:
Ich weiss nicht. Ubersetzen Sie auf english, bitte.

I can't answer the question, but he wrote:

When testing Fujitsu Controllers MB90F562 I get the problem that pin 26
(P01), which is used for the flash, dies, even though the pin isn't
touched during the test. Has anyone had similar problems? Is this pin
particularly prone to destruction due to the internal construction of
the controller?
 
Top