Maker Pro
Maker Pro

Flash erasing times

  • Thread starter Richard Hutchinson
  • Start date
R

Richard Hutchinson

Jan 1, 1970
0
Does age affect the erase time for Flash memory ?. I have a batch of
identical chips, some erase is 6 seconds other take 15 (datasheet specifies
10).
 
E

Eric Smith

Jan 1, 1970
0
Richard Hutchinson said:
Does age affect the erase time for Flash memory ?. I have a batch of
identical chips, some erase is 6 seconds other take 15 (datasheet specifies
10).

I wouldn't expect much effect as a strict function of age, but I would
expect that as the part is subjected to many erase cycles, they would
start to take longer.

I think manufacturing variation between lots could account for quite a
bit of variation.

But I'm not an expert on this stuff.
 
R

Rich Webb

Jan 1, 1970
0
Does age affect the erase time for Flash memory ?. I have a batch of
identical chips, some erase is 6 seconds other take 15 (datasheet specifies
10).

Be careful with datasheets. Is 10 sec specified as guaranteed maximum
erase time at a specific Vdd and temperature or is 10 the nominal?
 
R

Richard Hutchinson

Jan 1, 1970
0
is 10 the nominal?

Yes


I'll take it the one's with erase times of 15+ seconds are probably coming
to the end of their life.
 
R

Rich Webb

Jan 1, 1970
0
Yes


I'll take it the one's with erase times of 15+ seconds are probably coming
to the end of their life.

Not necessarily. If they don't spec a guaranteed maximum erase time,
there's probably a reason. A time of 15 secs could very well be within
the process variation for a part right off the manufacturing floor.
 
Top