Connect with us

Ferguson Tuned out

Discussion in 'Electronic Repair' started by auntie_biotic, Sep 17, 2003.

Scroll to continue with content
  1. I Have a Ferguson tv about 6 years old, tried to tune in a video channel
    through hand set, no tuning info came up on screen, now I cannot get any
    channels at all, just snow, the tv just has two small red lines where the
    channel number usually appears, tried turning off from the mains hoping it
    would reset but nothing just the two red lines. question .Is there a
    sequence off buttons on the hand set that I can press to reset the tv.The
    hand set has PR CH and I with four buttons below red , green , yellow ,
    blue. any help appreciated the kids are going nuts
     
  2. Eric

    Eric Guest

    what writing do you get on the screen when you press
    PR
    CH
    red
    green
    yellow
    blue
    buttons in turn?

    Note: CH stands for Channel that is the frequency channel number of the TV
    station.
    and PR stands for program number.


    : I Have a Ferguson tv about 6 years old, tried to tune in a video channel
    : through hand set, no tuning info came up on screen, now I cannot get any
    : channels at all, just snow, the tv just has two small red lines where the
    : channel number usually appears, tried turning off from the mains hoping it
    : would reset but nothing just the two red lines. question .Is there a
    : sequence off buttons on the hand set that I can press to reset the tv.The
    : hand set has PR CH and I with four buttons below red , green , yellow ,
    : blue. any help appreciated the kids are going nuts
    :
    : --
    : auntie_biotic
    : http://www.tbandu.co.uk
    :
    :
     
  3. Dont understand your meaning. Do not see anything bar "snow". I cannot get
    the tv to respond to remote at all.
    PS Have changed batteries
     
  4. Eric

    Eric Guest

    drats on it then


    : Dont understand your meaning. Do not see anything bar "snow". I cannot
    get
    : the tv to respond to remote at all.
    : PS Have changed batteries
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-