Maker Pro
Maker Pro

Fan regulator feedback generator

RahulSurawase

Jun 5, 2020
5
Joined
Jun 5, 2020
Messages
5
Hello Everyone,
I need help in to generate feedback for fan regulator to the controller.

1. AC Fan require 1 phase Ac supply (230VAC/50Hz)
2. Controller require DC voltage in range of 0 to 3V3
3. System is able to support all type regulator, there different type's of regulator available in market like Capacitive, phase controller (Electronics Regulator) and other's.
 

Bluejets

Oct 5, 2014
6,901
Joined
Oct 5, 2014
Messages
6,901
Why would it need feedback..?
Assuming you mean ceiling fan here...if not, then be more specific.
The ceiling fan motor runs at the supply frequency minus slip on high speed.
On lower speeds it's just a stab in the dark speed anyhow.
 

RahulSurawase

Jun 5, 2020
5
Joined
Jun 5, 2020
Messages
5
Consider only Dummy Fan regulator present in the switch board and it's integrated with controller circuit and there is digital fan regulator available on controller board
Controller need to sense manual change of fan regulator position which present on Switch board and controller adjust the fan speed by using digital regulator
what type of load i need to use with switch board Fan regulator, which I get easily change position difference voltage through it.
 

Bluejets

Oct 5, 2014
6,901
Joined
Oct 5, 2014
Messages
6,901
Show the specs and a circuit diagram of the complete system.
That way someone may be able to get some idea as to your application.
Other than that, crystal ball batteries are down this end.
 

RahulSurawase

Jun 5, 2020
5
Joined
Jun 5, 2020
Messages
5
This is the flow of circuit, Need to generate Feedback circuit with Dummy load which is compatible with All type of ceiling fan regulator
 

Attachments

  • BlockDiagram.PNG
    BlockDiagram.PNG
    99.1 KB · Views: 5
Top